Installing a Sky tvLINK to a second television.

Install a new cable from RF2 on the back of the SKY Digibox take directly to the second TV. (if distribution is required to more than one TV a SKY/Gobal 2 , 4, or 7 way amplifier unit will be required). If a TV outlet plate is used be sure that it is a non isolated type as power is required to pass from the Digibox.

SETING UP THE DIGIBOX.

1 Press the SERVICES button on your 'Digibox Remote Control'.(DRC)

2 Press the NUMBER 4 button on your DRC. (System Set-up)

3 Press the 0 then the 1 then the SELECT buttons (Installer menu)

4 Press NUMBER 4 again. (RF Outlets)

5 Press the DOWN ARROW button once. (second outlet power supply)

6 Then press the SIDE ARROW button once. (turning power ON)

7 Press the DOWN ARROW button once again.(save new settings)

8 Then press the SELECT button.

Installing the remote Eye.

Install the remote Eye into the rear TV Aerial input on the TV.

Fit “TV Fly Lead” from the wall outlet plate to the socket on the remote Ely interface. At this time you should now se the red LED alight, if not check all connections and that you have set-up the SKY Dgibox RF2 for power ON.

Can you change the SKY Digibox channels from the second television?

YES

Congratulations you have successfully installed you tvLINK Remote Happy viewing.

Fault finding.

Cover the infrared pick up on the front of the SKY Digibox and ensure the channels can not be changed when the remote control is pointed at it. (use a book or a video cassette, as the pick up on the front of the Digibox is extremely sensitive).

Disconnect the tvLINK remote from the second television and take it to your SKY Digibox.

Connect the tvLINK,remote female connector, directly onto the back of the Digibox (no cable just the tvLINK) into RFOut2, making sure the red LED is furthermost away from the Digibox.

Point the remote control at the tvLINK eye and try calling up the one of the menus. i.e. Services or, TV guide.

If it doesn't work at this location, uncover the front of the Digibox and enter back into the installer menu by following these instructions.

1 Press the SERVICES button on your 'Digibox Remote Control'.(DRC)

2 Press the NUMBER 4 button on your DRC. (System Set-up)

3 Press the 0 then the 1 then the SELECT buttons (Installer menu)

4 Press NUMBER 4 again. (RF Outlets)

5 Press the DOWN ARROW button once. (second outlet power supply)

6 Then press the SIDE ARROW button once. (turning power ON)

7 Press the DOWN ARROW button once again.(save new settings)

8 Then press the SELECT button.

9 Press the SELECT button again & re-enable the power to RF2 by repeating the instructions from number 6 to 8 turning the power on this time.

Even though the RFOut2 to shows as being 'ON' in the menus of your SKY Digibox, sometimes it will actually be off and following the above will reset it, and thus enabling your tvLINK.

Cover up the front of the Digibox and try the tvLINK, once again.

Installing a Sky tvLINK to a second television. Ó

Race Communications Ltd.