SETTING UP THE REMOTE CONTROL TO OPERATE YOUR TV
The Sky Digital
remote control can control both your Sky digibox and TV. If your Sky remote
control is not correctly operating your television, complete the following
steps.
Before you start, look up your four digit code for your brand of TV from the
code list.
TELEVISION CODE GUIDE
MAKE 4 Digit Code MAKE 4 Digit Code MAKE 4 Digit Code
Note: If your brand of TV is not listed
here, contact your broadcaster's helpdesk for further advice.
SETUP : Programming by code.
Step 1. Turn your TV on.
Step 2. Press tv on your Sky remote control.
Step 3. Hold down select and the red button together for about two
seconds, until the red light on the Sky remote control blinks twice.
If your TV is a Panasonic brand, simply key in 678 (instead of the four digit
code shown above).
The light on the remote control blinks twice.
Press the on/off button on your Sky remote control. If your TV switched off,
press the on/off button again and go to step 7.
If your TV did not switch off, please start again at Step 2 and key in 254.
Follow the above procedure and go to Step 7.
Step 4. Press tv on your Sky remote control again.
Step 5. Key in the four digit code for your brand of TV. The light on
the Sky remote control blinks twice. If the light blinks once only, re-check
the code for your brand of TV and start again at Step 2.
Step 6. Press the on/off button on your Sky remote control.
If your TV switched off, press select. The light on the Sky remote control
blinks twice. If TV did not switch off, press tv, then press the on/off button.
Repeat this (press tv, then on/off) until your TV turns off, then press select.
Note: If the light on your Sky remote control blinks three times, your Sky
digibox has checked all the possible settings for the code you used. Check that
you have the right 4 digit code and start again at Step 1.
Step 7. Turn your TV back on again and then press tv guide.
If you see the TV guide screen, the remote control setup process is complete.
If you did not see the TV Guide screen, you must now complete the following
steps.
Step 8. Press tv on your Sky remote control.
Step 9. Hold down select and green button together for about two
seconds, until the red light on the Sky remote control blinks twice.
Step 10. Key in the number of the channel on your TV that you use for
watching satellite TV.
Step 11. Press select on your Sky remote control. The red light blinks
twice. The remote control setup process is complete.
Race
Communications Ltd.